Post by yahnivek on Mar 13, 2014 10:28:57 GMT -5
Looking for some feedback on my first try at painting Chexx players. I went with the 2002 Team Canada Heritage red jersey's.
I'm not a very artsy guy so I need work steadying my hand but I think it turned out ok.
I used Krylon Plastic Flat white as the base and standard acrylic paint for the rest. For the logo I printed it out on avery sticker project paper 03383 and would highly recommend this after trying regular paper and clear address labels. I think the key for the logos is getting a high quality picture and changing the printing settings to the most advanced.
Any feedback is appreciated.
My next project is to modify the base for two purposes. 1) To raise it for better ergonomics. 2) So it can fit into smaller hallways and doors. I am going to cut the "flare" of the bottom of the base. This way the unit will fit through anything smaller than 27". I am then going to create a base out of lumber that is 12" high in which the existing base will sit in.
Doc3.docx (308.39 KB)
I'm not a very artsy guy so I need work steadying my hand but I think it turned out ok.
I used Krylon Plastic Flat white as the base and standard acrylic paint for the rest. For the logo I printed it out on avery sticker project paper 03383 and would highly recommend this after trying regular paper and clear address labels. I think the key for the logos is getting a high quality picture and changing the printing settings to the most advanced.
Any feedback is appreciated.
My next project is to modify the base for two purposes. 1) To raise it for better ergonomics. 2) So it can fit into smaller hallways and doors. I am going to cut the "flare" of the bottom of the base. This way the unit will fit through anything smaller than 27". I am then going to create a base out of lumber that is 12" high in which the existing base will sit in.
Doc3.docx (308.39 KB)